# Build
./chef.py -br -d rootnode_fan_7N2TobIlOX -t linux

# Run
./linux/out/rootnode_fan_7N2TobIlOX

# Commission
./chip-tool pairing code 0x20 MT:Y.XXX

# Turn fan ON (Initial default state is Off) and read SpeedCurrent and Speed Setting
./chip-tool onoff on 0x20 1
./chip-tool fancontrol read speed-current 0x20 1 | grep "SpeedCurrent" # 10 (speedMax)
./chip-tool fancontrol read speed-setting 0x20 1 | grep "SpeedSetting" # 10 (speedMax)

# Change SpeedSetting to 5 (medium) and read SpeedCurrent, SpeedSetting and FanMode
./chip-tool fancontrol write speed-setting 5 0x20 1
./chip-tool fancontrol read speed-current 0x20 1 | grep "SpeedCurrent" # 5
./chip-tool fancontrol read speed-setting 0x20 1 | grep "SpeedSetting" # 5
./chip-tool fancontrol read fan-mode 0x20 1 | grep "FanMode" # 2 (2 = medium)

# Turn Device Off and read SpeedCurrent, SpeedSetting and FanMode
./chip-tool onoff off 0x20 1
./chip-tool fancontrol read speed-current 0x20 1 | grep "SpeedCurrent" # 0 (changes to 0)
./chip-tool fancontrol read speed-setting 0x20 1 | grep "SpeedSetting" # 5 (unchanged)
./chip-tool fancontrol read fan-mode 0x20 1 | grep "FanMode" # 2 (unchanged)

# Turn Device On and read SpeedCurrent, SpeedSetting and FanMode
./chip-tool onoff on 0x20 1
./chip-tool fancontrol read speed-current 0x20 1 | grep "SpeedCurrent" # 5 (changes to SpeedSetting)
./chip-tool fancontrol read speed-setting 0x20 1 | grep "SpeedSetting" # 5 (unchanged)
./chip-tool fancontrol read fan-mode 0x20 1 | grep "FanMode" # 2 (unchanged)

# Send Off command, set speed setting to 0, then send On command and ensure fan is in HIGH state
./chip-tool onoff off 0x20 1
./chip-tool fancontrol write speed-setting 0 0x20 1
./chip-tool fancontrol read speed-current 0x20 1 | grep "SpeedCurrent" # 0
./chip-tool fancontrol read speed-setting 0x20 1 | grep "SpeedSetting" # 0
./chip-tool fancontrol read fan-mode 0x20 1 | grep "FanMode" # 0 (Off)
./chip-tool onoff on 0x20 1
./chip-tool fancontrol read speed-current 0x20 1 | grep "SpeedCurrent" # 10 (MAX)
./chip-tool fancontrol read speed-setting 0x20 1 | grep "SpeedSetting" # 10 (MAX)
./chip-tool fancontrol read fan-mode 0x20 1 | grep "FanMode" # 3 (HIGH)